The Honeywell 5800RPS is a wireless recessed roller plunger switch that provides concealed protection for doors and is so small it virtually disappears once installed. The 5800RPS is intended for use with only Honeywell control panels that support Honeywell 5800-Series devices. With features including a clean, fast installation, battery life of up to 7 years and exceptional range, you'll want to use it on every job where aesthetics and discretion are critical.
Each 5800RPS has its own unique serial number permanently assigned during manufacturing. The serial number is located on the label attached to the antenna. This should never be removed. The control panel is used to "enroll" the transmitter's ID during installation of the alarm system. The zone input should be set as "RF" type. It is recommended to use the 5800RPS on doors with a wood or metal frame, however, the wireless range may be reduced if used in metal frame doors. The long-life lithium battery is easily replaceable when a low battery condition is indicated on the control panel.
When mounting the 5800RPS begin by marking the selected location for the transmitter on the "hinge side" of the door frame at least 4' above the floor. Before drilling any holes, make sure that the successful Go/No Go transmission tests have been conducted to ensure it is within wireless range of the panel. Drill hole at the location marked for the transmitter (3/4" diameter, at least 1-2/4" in depth). Drill a second hole (1/4" in diameter, at least 8" in depth) at the center of the first hole for antenna insertion or insert the antenna into a space between the door frame and the stud framing. Insert the antenna into the provided straw. This is to make the installation easy and ensure the antenna will remain straight. Never coil or bunch up the antenna.
Continue by installation by inserting the 5800RPS transmitter and antenna assembly into the hole so that the transmitter flange is flush with the surface of the door frame. DO NOT hammer the transmitter into place with hard blows. Press into place either by hand or simply by closing the door, which presses it into place. Lastly, secure the transmitter by installing the two screws provided.