2GIG-FT1e-345 - 2GIG Wireless Encrypted Flood/Temperature Sensor (for eSeries Control Panels)
2GIG-FT1e-345 Product Description:
The 2GIG-FT1e-345 is a wireless eSeries encrypted flood and temperature sensor for 2GIG GC2e, GC3e or EDGE control panel. The 2GIG-FT1E-345 is the perfect sensor to alert the home owner of a flood or excessive change in temperature. The 2GIG-FT1e-345 is a fully supervised, tamper protected one-way 345 MHz encrypted sensor. It will monitor the ambient temperature of a space for high and low temperature thresholds and report changes outside of the defined settings. The FT1e-345 also has the ability to detect and report wet/dry flood condition in the event of the presence of standing water in the immediate sensor location. The FT1e-345 sensor reports wet/dry conditions and temperature to the panel.
To protect against flood conditions, simply mount the 2GIG-FT1e-345 sensor near a home's water heater or other contained water source and mount the sensor probe slightly above the floor. If a substantial leak occurs, the water will complete the circuit between the two probes on the sensor and a flood trouble or alarm will be sent to the panel. Once the 2GIG-FT1E-345 sensor probe detects the presence of water for three (3) minutes, the integral transmitter will send a wet alarm transmission to the security/control panel. The probe will also send a restore (dry) report when the presence of liquid is no longer detected by the flood probe for three (3) minutes. For flood reporting, the sensor requires the installation of the supplied external flood probe. The sensor is capable of detecting clean or dirty water, salt water or tap water.
Additionally, the 2GIG-FT1e-345 will monitor the ambient temperature approximately once per minute. If the temperature exceeds 95°F or drops below 42°F, for five (5) minutes the sensor will send a temperature trouble to the 2GIG security panel.
Product Features:
- Detects standing water that reaches the sensor probe and notifies the panel
- Sends trouble alert to the panel when the ambient temperature exceeds 84°F
- Sends trouble alert to the panel when the ambient temperature falls below 42°F
- Ships with long life lithium battery life (typical battery life of 5 years)
- 345 MHz frequency
- eSeries encryption
- Compatible with GC2e and GC3e panels
- ETL listed
2GIG-FT1e-345 Product Specifications:
- Wireless Signal Range: 275 ft. (80 m) open-air with Wireless Control Panel
- Code Outputs: Alarm; Alarm Restore; Supervisory Low Battery; Tamper; Tamper Restore; Trouble; Trouble Restore
- Transmitter Frequency: 345 MHz (crystal controlled)
- Supervisory Interval: 70 minutes
- Housing Material: ABS Plastic
- Operating Temperature: 32° to 120°F (0° to 49°C)
- Operating Relative Humidity: 5 to 95%, non-condensing
- Battery Type: CR2 3V lithium battery
- Projected Battery Life: 5 years
- Dimensions (Sensor): 2.92" H x 0.94" W x 0.85" D (74.17mm H x 23.88mm W x 21.59mm)
- Dimensions (Sensor Probe): 1.31" H x 1.34" W x 0.47" D (33.27mm H x 34.04mm W x 11.94mm)
- Dimensions (Sensor Probe in Probe Basket): 1.46" H x 1.54" W x 0.57" D (37.08mm H x 39.12mm W x 14.48mm D)
- Dimensions (Cord between Sensor and Probe): 45" cord with 0.169" Diameter (114.3cm cord) (4.29mm Diameter)
2GIG-FT1e-345 Product Documents:
• Data Sheet for 2GIG-FT1e-345 Wireless eSeries Flood & Temperature Sensor
• Installation/Operation Guide for 2GIG-FT1e-345 Wireless eSeries Flood and Temperature Sensor
2GIG-FT1e-345 Product Includes:
- (1) 2GIG Flood/Temperature Sensor
- (1) Sensor Mounting Plate
- (1) 3V Lithium Battery ( Panasonic CR15H270 uninstalled)
- (1) 3/8" Phillips Screws
- (1) Double Stick Tape Strip
- (1) Probe Mounting Plate
2GIG-FT1e-345 Product Requirements:
- Requires software firmware Version 1.14 or later for GC2 panel and 3.1 or later for GC3.
